Post New Thread Post Reply
Views:262 | Reply:1

Wiring Is The Key Of High-Frequency Circuit Design,Share Some Experiences!

pcbindex
December 22, 2017 14:52:41 Reply

All use of straight lines High-frequency circuit wiring is the better way , And if need to turning, the available 45° polylines or arcs turn, this requirement is used in low-frequency circuit only to improve the strength of copper foil.But in high-frequency circuits, it can reduce the launch of high-frequency signals and the coupling between each other.

The radiation intensity of the signal is proportional to the length of the signal line. The longer the signal frequency of the high frequency signal, the easier it is to couple to components close to it. So such as the, DDR, LVDS, USB, HDMI and other high-frequency signal lines are required as short as possible, the better the alignment.

Contact Us:

E-mail: service@pcbindex.com

chat with us online.Bottom right of website!

Place an order

Report a BUG

yulehappyboy
December 24, 2017 11:17:10 Reply

Thank you.