I/O Card Interface Connectors
3. ESD Secure
Thermoplastic molded covers assures insulation
of the connections and shields from ESD.
4. Secure Latching
A built-in latch assures correct and secure
mating of connector.
5. Reliable Conductor Termination
Reliable termination of conductors
accomplished by proven IDC termination.
6. Sequential Mating
The 0.8mm pitch contacts are engaging the
corresponding parts in sequence: Ground-
Power & Signal
7. Rugged Construction
1. Low Profile
Protorusion above the PCB Quote
board is only 2.9mm, and the
connectors can be mounted to type I and II I/O cards.
Securely attached to the board with optional
8. Card Frame Kits
Available as a separate part number.
2. EMI/RFI protection
Full metal shielding. Shield connects first, ahead of
9. Secure Attachment to Frame Kit.
Compliant mounting bracket attaches the
connectore directly to the frame kit.
Used with I/O cards, portable personal computers,and the external connections of various small-sized portable
Current rating 0.5 A
Voltage rating 125 V AC
1. Insulation resistance
2. Withstanding voltage
3. Contact resistance
-30ç to +70ç (Note 1) Storage temperature range -10ç to +60ç (Note 2)
95% R.H. or less
250 M ohms min.
No flashover or insulation breakdown.
40 m ohms max.
No electrical discontinuity of 10µs or
100 V DC
300 V AC / 1 minute
Frequency: 10 to 55 Hz, single amplitude of 0.75 mm,
2 hours in each of the 3 directions.
96 hours at temperature of 60ç and humidity of 90% to 95%
-55ç, 30 min./15 to 30ç, within 5 min/85ç, 30 min
to 35ç, within 5 min, for 5 cycles
Storage humidity range
40 to 70% (Note 2)
5. Humidity (Steady state)
Insulation resistance: 100 M ohms min.
6. Temperature cycle
8. Resistance to
No damage, cracks, or parts looseness.
60 m ohms max.
No deformation of components affecting
Reflow: At the recommended temperature profile
Manual soldering: 300ç for 3 seconds
Note 1: Includes temperature rise caused by current flow.
Note 2: The term "storage" refers to products stored for long period of time prior to mounting and use. Operating Temperature
Range and Humidity range covers non- conducting condition of installed connectors in storage, shipment or during